Zenmap scan subnet
| Some Capabilities: ConnectWithDatabase, Support41Auth, LongColumnFlag, SupportsTransactions, Speaks41ProtocolNew, SwitchToSSLAfterHandshake, SupportsCompressionĥ432/tcp open postgresql PostgreSQL DB 8.3.0 - 8.3.7Ĩ009/tcp open ajp13 Apache Jserv (Protocol v1.3)
|_http-server-header: Apache/2.2.8 (Ubuntu) DAV/2ġ39/tcp open netbios-ssn Samba smbd 3.X - 4.X (workgroup: WORKGROUP)Ĥ45/tcp open netbios-ssn Samba smbd 3.0.20-Debian (workgroup: WORKGROUP)ĥ13/tcp open login OpenBSD or Solaris rlogindġ524/tcp open bindshell Metasploitable root shellģ306/tcp open mysql MySQL 5.0.51a-3ubuntu5 |_smtp-commands: metasploitable.localdomain, PIPELINING, SIZE 10240000, VRFY, ETRN, STARTTLS, ENHANCEDSTATUSCODES, 8BITMIME, DSN,
#ZENMAP SCAN SUBNET CODE#
|_ftp-anon: Anonymous FTP login allowed (FTP code 230)Ģ2/tcp open ssh OpenSSH 4.7p1 Debian 8ubuntu1 (protocol 2.0) This scan uses a variety of scan options included in a single parameter: -A nmap 192.168.56.101 -A ┌─]─ Aggressive scanīe careful with this, as it is easily detectable. You can also exclude a whole range of IP addresses by using 192.168.56.1-100 for example. If you know for example that 192.168.56.1 is the router and you don’t want to run your scan against it, use the following.
#ZENMAP SCAN SUBNET FULL#
From this file we could create a full list of all IP addresses.It is also possible to exclude targets from a scan. You can use a file containing a list of IP addresses, subnets and hostnames, one per line to feed into Nmap. Select targets from a file using the -iL option. Use a dns server that is different than the default to perform reverse dns lookups -dns-server. For example you could scan a subnet and use the -exclude parameter to not scan an IP within that range. When selecting a large range of targets you may wish to specifically exclude some IP addresses. Further targeting parameters that may be of use -exclude If we however do not use the -n the command will attempt to resolve each IP address, this will take longer and will send dns queries. The commands in the above examples send no packets to the target systems, Nmap is simply listing the IP addresses in the subnet. ***** ctrl-c, listing all IP addresses will waste a lot of pixels ****** Testsystem:~$ nmap -sL -n 0.0.0.0/0 | grep 'Nmap scan report for' | cut -f 5 -d ' ' Want to list 4 billion IP addresses? Use the very same command to list all possible IPv4 addresses target 0.0.0.0/0. The target list can contain hostnames, IP addresses, subnets or a range of IPs such as 192.168.1.1-5. Additionally a second target range has been added to the target list. In the second example the results are piped through grep and cut to extract just the IP addresses we wanted in our list. Nmap done: 4 IP addresses (0 hosts up) scanned in 0.00 seconds Below we have listed the IP addresses in the target subnet -sL with no reverse DNS lookups -n